1. Autos
Send to a Friend via Email

Your suggestion is on its way!

An email with a link to:


was emailed to:

Thanks for sharing About.com with others!

You can opt-out at any time. Please refer to our privacy policy for contact information.

Discuss in my forum

Setting the Ignition Points Gap


Setting the Ignition Points Gap

Early Suzuki GS series bikes had dual point ignition systems. One set for cylinder 1 and 4, and one set for cylinders 2 and 3.

John H Glimmerveen Licensed to About.com

Setting the ignition timing on Japanese 4-cylinder, 4-stroke motorcycles starts with the contact points. Without the points gap being set, the timing cannot be properly checked or adjusted.

For the home mechanic with a good quality set of tools, setting the contact points is relatively easy and takes about half an hour to do.

As with all mechanical work on a motorcycle, cleanliness is important. The moving parts within the contact points mechanism can be damaged by small particles of dirt and the settings can be erroneous.

Clean With Compressed Air

With the above in mind, the points cover and surrounding case should be cleaned before attempting to check or set the points. In addition, to make it easier to rotate the engine, the spark plugs should be removed; again, with cleanliness in mind, the area around the plugs should be blown with compressed air before removing them.

The first part of the points setting phase is to determine the position of the piston, and also which stroke: inlet, compression, fire or exhaust.

Rotating the engine and observing when the inlet valve opens will determine the position. (If you are unsure of the rotation direction, rotate the engine by putting it into first gear then moving the rear wheel in the normal direction of travel). See note below.

Piston Position

The engine should be rotated until the piston is moving upwards on the compression stroke. (A regular plastic drinking straw placed through the plug hole onto the piston will show the position of the piston). At TDC (top dead center) the drinking straw will momentarily pause before descending; it is in this position when the contact points gap should be checked.

After setting the gap at TDC and locking the adjusting screw, the engine should be rotated one time and the gap rechecked.

As the points gap directly affects the ignition timing; it should be checked after any points gap adjustments. Also, the mechanic must be sure that he is measuring between the faces of the contact points and not onto the pip or nub that sometimes forms on the contacts.


  • Some Japanese motorcycles (Suzuki, for instance) have a 6 mm bolt locating the points cam onto the end of the crankshaft. Do not rotate the engine by this bolt as they can shear off. If this design is used on your engine, there will also be a large nut to rotate the engine in the same location. Alternatively, the engine can be rotated by the kick start lever, or by rotating the rear wheel.

©2014 About.com. All rights reserved.